Baldor FDH1A05TB-EN20 Installation Manual page 12

WARNING: MEDICAL DEVICE / PACEMAKER DANGER: Magnetic and electromagnetic
WARNING: Be sure all wiring complies with the National Electrical Code and all regional and
WARNING: The stop input to this equipment should not be used as the single means of
WARNING: Improper operation or programming of the drive may cause violent motion of the
WARNING: The motor circuit might have high voltages present whenever AC power is
WARNING: If a motor is driven mechanically, it might generate hazardous voltages that are
WARNING: When operating a rotary motor with no load coupled to its shaft, remove the shaft
WARNING: A regeneration resistor may generate enough heat to ignite combustible materials.
CAUTION: To prevent equipment damage, be certain that the input power has correctly sized
CAUTION: To prevent equipment damage, be certain that input and output signals are
CAUTION: To ensure reliable performance of this equipment be certain that all signals to/from
CAUTION: Suitable for use on a circuit capable of delivering not more than the RMS
MN1902
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
fields in the vicinity of current carrying conductors and industrial motors can result
in a serious health hazard to persons with cardiac pacemakers, internal cardiac
defibrillators, neurostimulators, metal implants, cochlear implants, hearing aids,
and other medical devices. To avoid risk, stay away from the area surrounding a
motor and its current carrying conductors.
local codes. Improper wiring may result in unsafe conditions.
achieving a safety critical stop. Drive disable, motor disconnect, motor brake and
other means should be used as appropriate. Only qualified personnel should
attempt to program, start-up or troubleshoot this equipment.
motor and driven equipment. Be certain that unexpected motor movement will not
cause injury to personnel or damage to equipment. Peak torque of several times
the rated motor torque can occur during control failure.
applied, even when the motor is not moving. Electrical shock can cause serious or
fatal injury.
conducted to its power terminals. The enclosure must be earthed/grounded to
prevent possible shock hazard.
key to prevent it flying out when the shaft rotates.
To avoid fire hazard, keep all combustible materials and flammable vapors away
from the brake resistors.
protective devices installed.
powered and referenced correctly.
the drive are shielded correctly.
symmetrical short circuit amperes listed here at rated voltage.
Horsepower RMS Symmetrical Amperes
1-50 5,000
www.baldormotion.com
General Information 1-3