Table of Contents
Advertisement
5.1 Introduction
Before powering the FlexDrive
install the supplied PC software Mint WorkBench. This software includes a number of tools to
allow you to configure and tune the FlexDrive
installation or Windows applications you may need further assistance for this stage of the
installation.
5.1.1 Connecting the FlexDrive
Connect the serial cable between a PC serial port (often labeled as "COM") to the FlexDrive
connector X6 (RS232/RS485). Mint WorkBench can scan all the COM ports, so you can use
any port.
CAUTION: The serial connector on the FlexDrive
5.1.2 Installing the software
The CDROM containing the software can be found separately within the packaging.
1. Insert the CDROM into the drive.
2. After a few seconds the setup wizard should start automatically. If the setup wizard does not
appear, select Run... from the Windows Start menu and type
d:\start
where d represents the drive letter of the CDROM device (use the correct letter for your
installation).
Follow the on-screen instructions to install Mint WorkBench. The setup wizard will copy the
files to appropriate folders within the C:\Program Files folder, and place shortcuts on the
Windows Start menu.
MN1902
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
II
you will need to connect it to the PC using a serial cable and
II
to the PC
RS232 or RS485 / RS422. If this is the first time you are installing a
II
FlexDrive
then it is strongly recommended that you use RS232 to get
started (the preset factory setting) and use RS485 later. Pin 9 is used to
carry +8V for powering a Baldor keypad peripheral. Ensure that pin 9 is
not connected to earth/ground or to equipment that could be damaged by
the +8V supply. A suitable cable is available from Baldor, catalog number
CBL001-501.
II
. If you do not have experience of software
II
(X6) can be configured as either
5
www.baldormotion.com
Operation
5
Operation 5-1
II
Advertisement
Table of Contents
