Table of Contents
Advertisement
Stratasys J826 User Guide
7. If the printer is currently loaded with seven Model materials, (High Mix /
8. Open the printer and remove the transparency.
DOC-28000 Rev. D
High Quality mode), select the mode for aligning the print heads.
Figure 4-61 Mode selection
When you click Next, the printer prints the head alignment test on the
transparency. When printing is finished, the following screen appears.
Figure 4-62 Head Alignment wizard—steps 8–10
The transparency sheet is printed with sets of vertical lines in seven
columns, each showing the results from a different print head.
Figure 4-63 Sample head-alignment test
Note: There is no column for head H7 because its alignment is used as a
reference for aligning all other heads.
4 Operating and Maintaining the Printer
4-47
Advertisement
Table of Contents
