New Module - Rockwell Automation Allen-Bradley ArmorBlock 5000 Series User Manual

Chapter 5 Configure the IO-Link Master Module
42
5. Select OK to save the configuration.
A prompt appears to request to inhibit the module. We recommend inhibiting the
module if the module is not fully configured or not ready to be put into operation
currently.
6. Repeat steps 3...5 to add another module, or close the Select Module Type dialog. If you
selected the Close on Create checkbox in step 3, you must start from step 2 to add
another module.

New Module

You can use the new module method when the project is offline or online.
To use the New Module method, complete these steps.
1. In the I/O Configuration tree, right-click the Ethernet network and select New Module.
The Select Module Type dialog appears.
Rockwell Automation Publication 5032-UM001A-EN-P - April 2023