Table of Contents
Advertisement
Discover Modules
To use the Discover Modules method, complete these steps.
1. Go online with your project.
The project must include a controller.
2. In the I/O Configuration tree, right-click the Ethernet network and select Discover
Modules.
The Select Module Type dialog appears. The Module Discovery tab shows the available
modules that are connected to the Ethernet network.
3. Select Create for the module that you want to add.
The New Module window appears and shows the General view. A list of different views is
shown on the left side. The number and type of views that are shown depend on your
Module Definition configuration.
4. Enter a name for the module, which is also used in the name of the Tag elements that
get created for the module.
If you want to configure the other settings during this step, see
Properties on page 44
Rockwell Automation Publication 5032-UM001A-EN-P - April 2023
Chapter 5
for more information.
Configure the IO-Link Master Module
Edit the Module
41
Advertisement
Table of Contents
Troubleshooting
