Table of Contents
Advertisement
Before You Begin
Register IO-Link Device
IODD
Configure the IO-Link Device
This chapter describes how to add and configure IO-Link devices that are connected to your
ArmorBlock 5000 8-channel IO-Link master module in a Studio 5000 Logix Designer
application project.
You must complete the following tasks before you can configure the IO-Link device.
1. Create a Studio 5000 Logix Designer application project.
2. Add a controller to the project.
3. Add and configure an ArmorBlock 5000 8-channel IO-Link master module.
For more information, see
Project on page
4. Set at least one channel mode to one of the following:
- "IO-Link"
- "Digital Input, Fallback"
- "Digital Input, Timestamp, Fallback"
Before using the IO-Link capabilities, verify the following:
•
The IO-Link master module and any associated field devices are working properly.
•
The field device is IO-Link capable.
•
Only one IO-Link device is connected to each port.
•
The IO-Link master module has established connection with the controller at least once
after the module has cycled power or has been reset.
Each IO-Link device has an associated IODD that contains information that is related to the
device.
Installing the AOP for IO-Link automatically registers the IODDs for a set of Rockwell
Automation IO-Link devices. If the IO-Link device that you want to use is not part of this set,
you must register the IODD for the device separately.
You can download IODD files for Rockwell Automation IO-Link devices from the Product
Compatibility and Download Center (PCDC) at rok.auto/pcdc.
For third-party IO-Link devices, you can download the IODD files from the manufacturer's
website or use the "IODDfinder" tool that is available on the IO-Link website at
search for the IODD files.
Rockwell Automation Publication 5032-UM001A-EN-P - April 2023
Add the Module to a Studio 5000 Logix Designer Application
40.
6
Chapter
io-link.com
to
61
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
