Io-Link Device Tags - Rockwell Automation Allen-Bradley ArmorBlock 5000 Series User Manual

Appendix C IO-Link Master Module and IO-Link Device Tag Definitions
Table 33 - IO-Link Master Module Status Tags (Continued)
Name
DLRNetworkState
DLRSupervisorState
DLREnabled
LocalClockOffset
LocalClockOffsetTimestamp
GrandMasterClockID
ChxxChyyDiagEvent.EventType
ChxxChyyDiagEvent.EventMode
ChxxChyyDiagEvent.EventCode
ChxxChyyDiagEvent.EventTimestamp

IO-Link Device Tags

106
Data Type Definition
SINT The status of the network.
SINT The status of the network supervisor.
BOOL Indicates if DRL network redundancy mode is enabled.
The offset in nanoseconds from the local clock to the
system time.
LINT
Use this value to detect steps in time. This value
updates when a PTP update is received.
The most recent time the LocalClockOffset was
sampled.
LINT
The initial value is zero and the first time stamp occurs
when the module synchronizes with the master clock.
The EUI-64 Identity of the CIP Sync Grandmaster clock
SINT[8]
that the module is synced to.
USINT Indicates the type of event.
USINT Indicates the event mode.
UINT The value that represents the event.
LINT The time stamp of the event.
Every type of IO-Link device has a set of common tags. For device-specific IO-Link tags, see
the documentation for that device.
The following types of tags are available:
• Configuration Tags for IO-Link Device
• Input Tags for IO-Link Device
• Output Tags for IO-Link Device
Rockwell Automation Publication 5032-UM001A-EN-P - April 2023
Valid Values
• 0 = Normal
• 1 = Ring Fault
• 2 = Unexpected Loop Detected
• 3 = Partial Network Fault
• 4 = Rapid Fault/Restore Cycle
• 0 = Device is functioning as a backup
• 1 = Device is functioning as the active ring supervisor
• 2 = Device is functioning as a normal ring node
• 3 = Device is operating in a non-DLR topology
• 4 = Device cannot support the current ring
parameters (Beacon Interval and Beacon Timeout)
0 = DLR is not enabled
1 = DLR is enabled
All values
N/A
All values
• 1 = Notification
• 2 = Warning
• 3 = Error
• 1 = Event single shot
• 2 = Event disappears
• 3 = Event appears
All positive values
All positive values
(as indicated by a 'C')
(as indicated by an 'I')
(as indicated by an 'O')