Rockwell Automation Allen-Bradley ArmorBlock 5000 Series User Manual page 55

Table 12 - Event Definition Tags
Task
Enable the event.
Determine if an input state change on any
single selected point or a pattern of input
state changes across all selected points
triggers the event.
Select at least one channel on the module to
participate in the event.
For all channels that participate in the event,
determine what constitutes an event state.
Determine which edge of the event triggers
the event. That is, the rising edge, falling
edge, or either edge of the event.
Determines whether to latch the event.
Event Definition
Table 12 describes the event definition parameters that you can configure using the Event
Output tags.
Event Output Tag to Change
EO.Eventxx.En
EO.Eventxx.IndependentConditionTriggerEn
The tag name changes based on the input function. The
following names are available:
• EO.Eventxx.PtxxDataSelect – This tag appears for any
channel that is configured as "Digital Input" or "Digital
Input, Timestamp".
• EO.Eventxx.CounterxxSelect – This tag appears for any
channel that is configured as "Digital Input, Counter".
The tag name changes based on the input function. The
following names are available:
• EO.Eventxx.PtxxDataValue – This tag appears for any
channel that is configured as "Digital Input" or "Digital
Input, Timestamp".
• EO.Eventxx.CounterxxValue – This tag appears for any
channel that is configured as "Digital Input, Counter".
Both of the following:
• EO.Eventxx.EventRisingEn
• EO.Eventxx.EventFallingEn
EO.Eventxx.LatchEn
Rockwell Automation Publication 5032-UM001A-EN-P - April 2023
Chapter 5 Configure the IO-Link Master Module
Valid Values
0 = Event is disabled
1 = Event is enabled
0 = Pattern of input state changes triggers the event
1 = Single input state change triggers the event
0 = Point does not participate in the event trigger
1 = Point participates in the event trigger
0 = On to Off state transition
1 = Off to On state transition
The combination of the tag settings determines which edge
triggers the event:
• This combination triggers the event on a rising edge:
– EO.Eventxx.EventRisingEn = 1
– EO.Eventxx.EventFallingEn = 0
• This combination triggers the event on a falling edge:
– EO.Eventxx.EventRisingEn = 0
– EO.Eventxx.EventFallingEn = 1
• This combination triggers the event on either a rising or
falling edge:
– EO.Eventxx.EventRisingEn = 1
– EO.Eventxx.EventFallingEn = 1
0 = Event is not latched
1 = Event is latched
55