Installation; Introduction; Safety; Optional Equipment - CTEK CHARGESTORM CONNECTED 2 User Manual

Installation

Introduction

This part of the instructions shows how to install the
charging station CHARGESTORM® CONNECTED.

Safety

• Only an accredited electrician is allowed to
perform the installation described in this
document.
• Read and follow the instructions in this
document before installation and operation of
the product.
• Installation must fulfill local safety regulations.
• Do not use adaptors or conversion adapters
with this product, according to IEC61851
standard requirements.
• This charging station does not have ventilated
charging.
• Make sure the cables in the charging station
are not loose due to vibrations during
transportation. If any cables are loose,
reconnect the cables and tighten the screws.
• The installation is recommended to be carried
out by two persons.
• Use safety shoes during installation.
Tools
> 2000 mm
Mini-USB
CTEK AB
• Mifare Classic/IEC 14443 Type A and
compatible RFID tag (in case RFID shall be
used).
• Computer/Laptop (OS: Linux or OSX is
recommended, Windows 10/11 requires USB
driver installation).

Optional equipment

• Pole mount kit for a pole diameter of 60 mm.
Article number 920-00010 (only if added).
• Pole mount kit for two boxes, to enable
maximum four EV connectors from one pole.
Article number 922-00018.

To check before installation

Carry out the following checks prior to cable
installations:
1. Avoid installation of the EV charger in direct
sunlight. If the product is installed in direct
sunlight, symbol visibility is decreased and the
temperature of the product increases. This will
trigger the overheating protection and limit the
charging current.
2. Decide if the unit should be installed outdoors
or indoors.
a For outdoor installation, the power cable
and network cable are recommended to be
installed from below to prevent water from
entering the technical box from the top.
User & installation instructions
For indoor installation, the power cable and
b.
network cables can be installed either from
the top or from the bottom of the technical
box.
NOTE: For installations with a power cable
diameter greater that 17 mm, the power
cable must be installed from below.
To prepare the location for
installation
1. Determine the mounting position of the charg-
ing station.
a. Make sure that there is enough space
available for normal operation.
Min
Min
350 mm
300 mm
1100-
1500 mm
500-
12-24 kg
1500 mm
b. When installing on a wall, make sure that
the wall material is suitable for mounting of
the box. The wall must withstand the weight
of the charging station. Do not install the EV
charger in any enclosures.
c. For installation on a pole, refer to the
manual for the pole mount kit.
To install the charging station on a
wall using the mounting bracket
246
43
[mm]
224
13
80
160
1. Drill five holes in the wall that align with the
locations shown in the drilling template.
Unlock and open the technical box with the key.
2.
3. Carefully remove the protection cover.
5