NXP Semiconductors QorIQ LS1028A Reference Manual page 44

Mikro-click modules
From I2C MUX
From UART2
MUX
LS 1028A
OVDD
(1.8V)
The following table describes some of the mikro-click modules (boards) that can be used
on the mikroBUS sockets.
Module
BLE module
BLE P Click
BEE module
BEE click
NFC module
NFC click
The LS1028A processor supports serial peripheral interface (SPI3) controller. The SPI3
pins are used to access the two mikroBUS sockets connected on the board. However,
only one mikroBUS connector can be used at a time as SPI3 supports only one chip
select.
QorIQ LS1028A Reference Design Board Reference Manual, Rev. A, 02/2018
44
CFG_MUX_uBUS1/2_SPI_B,
CFG_MUX_uBUS1/2_UART_B,
CFG_MUX_uBUS1/2_PWM_B
I2C_CH6/CH7
UART2_SOUT/SIN
Level
Translator
CLKOUT/
1.8V>3.3V
FTM1_CH1
SPI3_SOUT,
SPI3_SIN,
SPI3_PCS,
SPI3_SCK
Figure 2-17. mikroBUS architecture
Table 2-14. Mikro-click modules
Communication interface
SPI
SPI
I2C, GPIO
Confidential Proprietary
CPLD
MUX
CTL
RESET
uCLICK1_UART
uCLICK1_PWM
uCLICK1_SPI
I2C1_CH6
uCLICK2_UART
uCLICK2_PWM
uCLICK2_SPI
I2C1_CH7
Part number
MIKROE-1597
MIKROE-987
MIKROE-2395
INT
BLE Module
BLE-P-Click
BEE Module
BEE-Click
NFC Module
NFC-Click
Description
Module supports Bluetooth
4.0 on the board. This module
communicates with
LS1028ARDB through SPI
(CS, SCK, MISO, MOSI), INT
(RDY) and AN (ACT) lines on
mikroBUS socket.
Module features a 2.4 GHz
IEEE 802.15.4 radio
transceiver module to support
wireless communication
applications.
It is a near field
communications (NFC)
controller from NXP.
NXP Semiconductors