Passenger Air Bag (Inflator) Module Inspection; Side-Air Bag (Inflator) Module Removal And Installation - Suzuki Grand Vitara 2011 Manual

8B-103 Air Bag System:

Passenger Air Bag (Inflator) Module Inspection

WARNING
!
• Never measure resistance of passenger air
bag (inflator) module or disassemble it.
Otherwise personal injury may result.
• Never attempt to disassemble or repair the
passenger air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System",
"Precautions on Handling and Storage of
Air Bag System Components" and
"Precautions on Disposal of Air Bag and
Seat Belt Pretensioner" before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.
CAUTION
!
If air bag (Inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
replaced.
Check air bag (inflator) module appearance visually for
the following symptoms and if any one of them is found,
replace with a new one.
• Air bag has deployed.
• Wire harness or connector is damaged.
• Air bag (inflator) module is damaged or a strong
impact was applied to it.
• Bend or deformity of air bag (inflator) module bracket.
Side-Air Bag (Inflator) Module Removal and
S6JB0A8206008
Installation
WARNING
!
• Never attempt to disassemble or repair the
side-air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System",
"Precautions on Handling and Storage of
Air Bag System Components" and
"Precautions on Disposal of Air Bag and
Seat Belt Pretensioner" before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.
Removal
1) Disable air bag system. Refer to "Disabling Air Bag
System".
2) Roll up the seat surface of the seat back.
3) Remove sleeve lock nut (1) from seat back (2).
I5JB0A820084-02
4) Remove side-air bag (inflator) module from seat
back.
5) Disconnect side-air bag (inflator) module connector
(1) as shown in figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
1
2
2
1
S6JB0A8206009
I4RS0A820067-01
a)
b)
I4RS0A820068-01