Suzuki Grand Vitara 2011 Manual page 1740

8B-109 Air Bag System:
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Remove center pillar lower trim and side sill scuff.
4) Disconnect side-sensor connector sliding connector
outer (1) as shown.
5) Remove side-sensor bolts (1), and side-sensor (2)
from under body (3).
3
1
1
1
I5JB0A820094-01
2
I5JB0A820093-02
Installation
CAUTION
!
Proper operation of side-sensor requires that
sensor is rigidly attached to specified
position.
1) Check that none of following faulty conditions exists.
• Bend, deformity or rust of under body.
• Foreign matter on mating surface of sensor.
2) Install side-sensor (1) on under body (2) and tighten
side-sensor bolt (3) to specified torque.
Tightening torque
Side-sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
3, (a)
3) Connect side-sensor connector pushing connector
inner (1) as shown.
1
1
4) Connect negative cable at battery.
5) Enable air bag system. Refer to "Enabling Air Bag
System".
2
1
I5JB0A820095-02
I5JB0A820096-01