Suzuki Grand Vitara 2011 Manual page 1672

8B-41 Air Bag System:
Step
3 1) With ignition switch OFF, disconnect special tools (B)
and (C) or (D) from "G26" or "G27" connector and
reconnect contact coil connector located under of the
steering column.
2) Remove driver air bag (inflator) module from steering
column referring to "Driver Air Bag (Inflator) Module
Removal and Installation".
3) Check proper connection to driver air bag (inflator)
module connector.
4) If OK, then connect special tools (A), (B) and (E) to
driver air bag (inflator) module connector.
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–78340
(D): 09932–77320
(E): 09932–78310
(E)
(B)
5) Check SDM DTC.
With ignition switch ON, is DTC B1034 indicated?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
(A)
STEERING WHEEL
I5JB0A820028-01
Yes
Turn ignition switch
OFF. Replace contact
coil assembly referring
to "Contact Coil Cable
Assembly Removal and
Installation in Section
6B".
No
Turn ignition switch
OFF. Replace driver air
bag (inflator) module
referring to "Driver Air
Bag (Inflator) Module
Removal and
Installation".