Driver Air Bag (Inflator) Module Removal And Installation - Suzuki Grand Vitara 2011 Manual

CAUTION
!
• Do not connect a tester whatever type it
may be.
• Never repair or disassemble SDM.
• If SDM has been dropped, it should be
replaced.
If any faulty condition is found in the following checks,
replace.
• Check SDM for dents, cracks or deformation.
• Check SDM connector for damage, cracks or lock
mechanism.
• Check SDM terminal for bend, corrosion or rust.
Driver Air Bag (Inflator) Module Removal and
Installation
WARNING
!
When handling an air bag (inflator) module,
be sure to read "Precautions on Handling
and Storage of Air Bag System Components"
and observe each instruction. Failure to
follow them could cause a damage to the air
bag (inflator) module or result in personal
injury.
Removal
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Remove steering wheel side caps (2).
4) Loosen driver air bag (inflator) module mounting
bolts (1) till it turns freely, pull them out and fix them
to bolt clamps.
1
2
5) Remove air bag (inflator) module from steering
wheel.
6) Disconnect driver air bag (inflator) module connector
(1) of driver air bag (inflator) module as shown in
figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
S6JB0A8206005
Installation
1) Connect driver air bag (inflator) module connector
(1) to driver air bag (inflator) module (2) securely as
shown in figure.
a) Connect connector.
b) Lock connector with lock button (3).
1
2
I5JB0A820075-01
Air Bag System:
2
a)
b)
1
3
b)
a)
1
8B-100
I5JB0A820076-01
2
I5JB0A820077-01