Panasonic FP7 Series Command Reference Manual page 709

Hide thumbs Also See for FP7 Series:

Table of Contents

Example 18) Converting two hexadecimal ASCII data (separated by commas, with

spaces) to two 16-bit binary data (hexadecimal)

The conversion starts from the high byte of DT0. It is converted in reverse direction (the low

word side of [S2] is considered as high-order numerical data). It is processed considering

commas as the data delimiters. If a space is inserted after numerical data, the space is ignored

and the numerical data is converted.

② Conversion starting position = + 1 byte

③ Amount of data to be converted = 2

DT0 to DT2: "123" → DT100: H0123

DT3 to DT5: "AB" → DT101: H04AB

Flag operations

WUME-FP7CPUPGR-12

Converts hexadecimal ASCII data to 16-bit data

① ASCII data (reverse direction)

② Conversion starting position (1) → [S2] + 1 byte

③ Amount of conversion data (2) → 2 data separated by a comma

Set when the range is exceeded during indirect access (index modification).

To be set when the conversion format specified by [S1] is not an available operation unit.

To be set when the conversion format specified by [S1] is not a control string.

To be set when the number of digits for the conversion format specified by [S1] is 28 or

To be set when the number of digits for the conversion format specified by [S1] is omitted,

and the string for [S2] is specified with 28 or more digits without delimiters.

To be set when the ASCII data specified by [S2] is a string that cannot be converted.

Example 1) When the operation unit is US and the value exceeds the maximum number for

conversion "65535"

Example 2) When the strings for conversion contain characters other than values that can

be converted (0 to 9, A to F)

To be set when the beginning of conversion specified by [N] exceeds the [S2] area.

To be set when the conversion data amount specified by [N] exceeds the [S2] area.

To be set when the conversion data amount specified by [N] is out of the range.

To be set when the conversion result exceeds the area specified by [D].

14.11 ATOB (Conversion: ASCII → BIN)