Smtpcset (Mail Transmission Setting) - Panasonic FP7 Series Command Reference Manual

17.24 SMTPcSET (Mail Transmission Setting)

17.24 SMTPcSET (Mail Transmission Setting)
■
Ladder diagram
(Note 1) The above figure shows the case that S1=U100 (built-in ET-LAN in the CPU unit) and S2=U1
(connection number 1) are specified by the UNITSEL instruction. Set a desired value for [S2].
(Note 2) By copying and pasting the following text in the instruction list box of FPWIN GR7, the operand part of
the above program can be input.
SMTPcSET "ID=0,TRIG=BITON,R0" "GRPNO=0,SUBJECTAUTO" "Test" "INFO=NON,ATT=NONE"
■
List of operands
Operand Description
Starting address of the device area that stores the string data that indicates a setting number and a
S1
send trigger, or a character constant
Starting address of the device area that stores the string data that indicates the destination group
S2
number and the subject of the mail to be sent, or a character constant.
Starting address of the device area that stores the string data that indicates the text of the mail to
S3
be sent, or a character constant.
Starting address of the device area that stores the string data that indicates the attached data
S4
specification of the mail to be sent, or a character constant.
■
Devices that can be specified (indicated by ●)
Operan
d
W W
X Y
S1 ● ●
S2 ● ●
S3 ● ●
S4 ● ●
■
Outline of operation
● This instruction configures the mail transmission settings.
● Before executing this instruction, use the
instruction or the programming tool software "FPWIN GR7" to configure event mail settings.
17-120
16-Bit device:
W W W S D L
R L S D T D
● ● ● ●
● ● ● ●
● ● ● ●
● ● ● ●
32-Bit
device:
TS TE
U W
WI IX
C C
M O
S E
"17.23 SMTPcADD (Destination Group Setting)"
Real St
Integer numbe rin
r g
D
K H SF " "
Ｕ
F
●
●
●
●
WUME-FP7CPUPGR-12
Index
modifie
r