Panasonic FP7 Series Command Reference Manual page 879

[S] value
0
1
■
Acquired data (number of F link services): When [S] = 0
Storage
Items
location
[D] F link service counter
■
Acquired data (F link operation state monitor): When [S] = 1
Storage
Items
location
[D] to [D+1] Connected unit
[D+2] to [D
Abnormal unit current value
+3]
[D+4] to [D Abnormal unit cumulative
+5] value
[D+6] to [D Setting of slave unit where
+7] I/O verification error occurred
Slave unit where
[D+8] to [D
instantaneous power failure
+9]
occurred
■
Flag operations
Name
SR7
SR8
(ER)
WUME-FP7CPUPGR-12
16.5 PMGET (Acquiring MEWNET-F Parameters)
Type of acquired data
Number of F link services
F link operation state monitor
Range:
U0 to U65535
Description
To be set in the case of out-of-range in indirect access (index modification, pointer access).
To be set when the destination range is outside the accessible range.
To be set when the FP7 multi-wire link unit does not exist in the slot that is specified by
UNITSEL.
To be set when the COM port specified by UNITSEL does not exist.
To be set when the parameter storing device that is specified by [D] is invalid.
Number of stored
data
1 word
10 word
Description
Service ring counter of master unit
Range: Description
Bit 0 to bit 31: Unit number 1 to unit number 32
OFF: Disconnected unit
ON: Connected unit
H0 to
HFFFFFFFF
Bit 0 to bit 31: Unit number 1 to unit number 32
OFF: Normal unit
ON: Abnormal unit
Storage location
[D]
[D] to [D+9]
16-19