Panasonic FP7 Series Command Reference Manual page 1011

Hide thumbs Also See for FP7 Series:

Table of Contents

Setting example

"ID=0,TRIG=BITON,DT100.1"

Setting number: 0, Send trigger: Bit device (Global device: DT100 Bit 1 )

"ID=1,TRIG=TIME,/day,13:30:00"

Setting number: 1, Send trigger: Time (Every day at 13:30)

"ID=2,TRIG=TIME,/year,4:1:9:0:0"

Setting number: 2 Send trigger: Time (Every year at 9:00 on April 1)

"ID=3,TRIG=TIME,/week,23:50:00-5"

Setting number: 3, Send trigger: Time (Every week at 23:50 on Friday)

"ID=4,TRIG=CYCLIC,30SEC"

Setting number: 4, Send trigger: Cycle (30-second cycle)

"ID=5,TRIG=CYCLIC,10MIN"

Setting number: 5, Send trigger: Cycle (10-minute cycle)

"ID=6,TRIG=CYCLIC,12HOUR"

Setting number: 6, Send trigger: Cycle (12-hour cycle)

"ID=7,TRIG=PROGRAM"

Setting number: 7, Send trigger: Instructions

"ID=8,TRIG=STATUS,PROG>RUN"

Setting number: 8, Send trigger: PLC status change (When the switch changes PROG to RUN)

"ID=9,TRIG=STATUS,RUN>PROG"

Setting number: 9, Send trigger: PLC status change (When the switch changes RUN to PROG)

"ID=10,TRIG=STATUS,ERR>STOP"

Setting number: 10, Send trigger: PLC status change (When operation stop self-diagnostic error is

WUME-FP7CPUPGR-12

17.24 SMTPcSET (Mail Transmission Setting)

When switching the swtich PROG to RUN

When switching the swtich RUN to PROG

Operation stop self-diagnostic error detected.

Operation continue self-diagnostic error detected.

When error is cleared