Smtpcreq (Mail Send Request) - Panasonic FP7 Series Command Reference Manual

17.26 SMTPcREQ (Mail Send Request)

■
Ladder diagram
(Note 1) The above figure shows the case that S1=U100 (built-in ET-LAN in the CPU unit) and S2=U1
(connection number 1) are specified by the UNITSEL instruction. Set a desired value for [S2].
■
List of operands
Operand Description
S Specify the device address where the transfer number (0 to 15) is stored, or a constant.
■
Devices that can be specified (indicated by ●)
Operan
d
W W
X Y
S ● ●
■
Outline of operation
● This instruction requests to send a mail.
● Before executing this instruction, use the "SMTPcSET" instruction or the programming tool
software "FPWIN GR7" to configure event mail settings.
■
Processing
● The send request relay for the send number that is specified by [S] is turned ON.
● This instruction can be executed when the cable disconnection detection flag (X60) is OFF.
As an execution condition of the instruction, insert a program that checks the status of the
flag (X60). If this instruction is executed when the flag (X60) is ON, the system relay SR9
(carry flag CY) is set and the instruction is terminated without being executed.
● This instruction can be executed when the Ethernet initialization active flag (X61) is OFF. As
an execution condition of the instruction, insert a program that checks the status of the flag
(X61). If this instruction is executed when the flag (X61) is ON, the system relay SR9 (carry
flag CY) is set and the instruction is terminated without being executed.
● This instruction can be executed when the SMTP client preparation done flag (X69) is ON.
As an execution condition of the instruction, insert a program that checks the status of the
WUME-FP7CPUPGR-12
16-Bit device:
W W W S D L
R L S D T D
● ● ● ●
17.26 SMTPcREQ (Mail Send Request)
32-Bit
device:
TS TE
U W
WI IX
C C
M O
S E
Real St
Integer numbe rin
r g
D
K H SF " "
Ｕ
F
● ●
Index
modifie
r
●
17-135