List Of System Data Registers - Panasonic FP7 Series Command Reference Manual

20.2 List of System Data Registers

SD0-SD28
Device
Name
No.
SD0 Self-diagnostic error code
Alarm Occurrence Unit Slot
SD1
No.
Error Occurrence Unit Slot
SD2
No.
Warning Occurrence Unit Slot
SD3
No.
Verification Error Occurrence
SD4
Unit Slot No.
Installation error detection
SD5
slot No.
Memory configuration
SD6
inconsistency details
Operation error occurrence
SD7
PB number (hold type)
Address with operation error
(hold type)
SD8
(32-bit lower address)
Address with operation error
(hold type)
SD9
(32-bit higher address)
Operation error occurrence
SD10
PB number (latest type)
Address with operation error
(new type)
SD11
(32-bit lower address)
WUME-FP7CPUPGR-12
20.2 List of System Data Registers
Description
Stores the error code when a self-diagnosis error occurred.
Saves the slot number of the unit where an alarm has occurred.
Slot No.1 to 64
Stores the slot number of the unit in which the error occurred or the
slot number of the CPU unit with built-in ET-LAN.
Slot No.1 to 64, 100 (CPU unit with built-in ET-LAN)
Stores the slot number of the unit in which the warning occurred or
the slot number of the CPU unit with built-in ET-LAN.
Slot No.1 to 64, 100 (CPU unit with built-in ET-LAN)
Saves the slot number of the unit where a verification error has
occurred.
Slot No.1 to 64
Saves the slot number of the unit where an installation error was
detected.
Slot No.1 to 64
When a memory configuration inconsistency is detected, information
about the setting where the error has occurred is saved
Bit No.
0
1
2
3
4
5
6
Saves the PB number where the first operation error occurred after
the unit has started operating.
Saves the address where the first operation error occurred after the
unit has started operating. Perform monitoring using 32-bit data.
Saves the PB number where an operation error occurred. Every time
a new error occurs, the data are updated. The value '0' is recorded
at the start of the scan.
Saves the address where an operation error occurred. Every time a
new error occurs, the data are updated. The value '0' is recorded at
the start of the scan. Perform monitoring using 32-bit data.
Description
Logging/Trace settings
FTPc settings
HTTPc settings
Mailc settings
EIP settings
W-PLC link settings
W2-PLC link settings
20-9