Panasonic FP7 Series Command Reference Manual page 977

Setting item Settings
Transfer setting
S1
number
(Note 1) Transfer setting numbers should be specified from number 0 in ascending order. An error occurs when
transfer setting numbers are not specified in ascending order. If transfer settings have been already
registered, this rule is not applied.
Setting example
Exam
S1 "ID=1"
ple 1
Settings Transfer setting number: 1
Exam
S1 "ID=8"
ple 2
Settings Transfer setting number: 8
■
Operand [S2] setting
● Specify the starting address of the device area that stores the string data that indicates the
parameters for operation setting, or a character constant.
Setting item Settings
Specification of
HTTP server
Target and
S2
operation of
transfer
Command used
(Note 1) Input each operation setting parameter separated by a comma ",".
(Note 2) The operation setting parameters cannot be omitted.
Setting example
Exam
S2 "SV3,UPLOAD,POST"
ple 1
Settings HTTP server: 3, Target: Device, Operation: Send (UPLOAD), Command used: POST (Fixed)
Exam
S2 "SV0,UPLOAD,POST"
ple 2
Settings HTTP server: 0, Target: Device, Operation: Send (UPLOAD), Command used: POST (Fixed)
WUME-FP7CPUPGR-12
17.17 HTTPcSET (HTTP Client Transfer Setting)
Specify a transfer setting number.
ID=: Transfer setting number
Specify HTTP servers. (3 digits fixed)
SV0: Server 0
SV1: Server 1
SV2: Server 2
SV3: Server 3
Specify the target (device) and operation (Send or Get) of transfer.
UPLOAD The target is Device, and the operation is Send.
DOWNLOAD The target is Device, and the operation is Get.
UPDOWN The target is Device, and the operation is Send and
Get.
Specify a command to be used for transfer.
POST: POST command is used
GET: GET command is used
* Only POST can be specified for Upload or Upload and Download.
Setting
range
0 to 15
17-89