Panasonic FP7 Series Command Reference Manual page 867

■
Available bit devices (●: Available)
Operand
X
S1
(Note 1)
●
S2
n
D1 ●
D2
(Note 1) When the sender is FP7, only global devices can be specified. (A local device cannot be specified.)
■
Outline of operation
● Data can be transferred from the partner unit to the master unit between PLCs connected by
MEWNET-W or MEWNET-W2.
● When the RECV instruction is executed, the data is read from the address that starts with
[S2] in the partner station number [S1] and the data is stored in the area that starts with [D1]
in the master unit.
■
Specification of partner unit station number [S1]
Communication Mode
W mode
W2 mode
■
Specify the starting address [S2] of the sender data area
Transfer method
Register transfer
Bit transfer
(Note 1) The transfer method varies according to the device type specified for operands [S2] and [D1]. The
register transfer is used for 16-bit devices and the bit transfer is used for 1-bit devices.
16-bit device: WX, WY, WR, WL, DT, LD
1-bit device: X, Y, R, L, DT.n, LD.n
(Note 2) The bit devices DT, n, LD and n cannot be specified for the starting address of the source data of
partner unit.
(Note 3) When the receiver is the file register FL, specify a constant. Example) For FL100, specify U100. For
the file register, only bank 0 can be specified.
WUME-FP7CPUPGR-12
16.2 RECV (When FP7 Multi-wire Link Unit Is Used)
Bit device
Y R L T C
● ● ●
● ● ●
Communication Mode
W mode
W2 mode
W mode
W2 mode
Device specified in [S2] and [D1]
P E SR IN OT
Address range
0 to 65535
0 to 65535F
Specification of bit of
word device
DT.n LD.n
● ●
● ●
Setting range
1 to 32
1 to 64
Transfer method
Register
transmission
Bit transmission
Index
modifier
●
●
16-7