Kodak Ektascan 2180 User Manual page 243

Changing the Rear Film Stop Assemblies
In the Lid of the Supply Magazine, there is a pair of Rear Film Stop Assemblies that
keeps the film in place within the Magazine. This pair of Assemblies must be located in
the appropriate location for the size of film that is used. The following illustration shows
all of the different possible locations for the Rear Film Stop Assemblies in the Lid of the
Supply Magazine.
Also located in the Lid of the Supply Magazine is a Comb Assembly which lines up with
the teeth on the Spindle to pull the film package from the film. The location of the Comb
Assembly does not change.
To change the location of the Rear Film Stop Assemblies, you will need a Torx T10
driver.
rear film
stop assemblies
5B9615
8 x 10 in.
11 x 14 in.
35 x 35 cm
35 x 45 cm
comb assembly
H126_6336GCA
Appendix
H126_6336GA
18–5