Auxiliary Keypad - Kodak Ektascan 2180 User Manual

User's Manual

Auxiliary Keypad

Introduction
The Auxiliary Keypad is a standard keypad that is used with an autofilming link. The
Auxiliary Keypad is available to some autofilming imaging devices. With certain
imaging devices, the keypad functions in Display Mode only. In others, the user may
switch from Display Mode to Active Keypad Mode.
Note
Consult your Kodak representative for the modes available with your imaging device.
Display Mode
When the auxiliary keypad is attached in addition to the autofilming link, and the Laser
Printer and imaging device are powered on, the following screen could appear on the
keypad display.
DISPLAY MODE
F2 TO SWITCH CONTROL
If the [F2] key is not pressed, the autofilming link controls the Laser Printer. The Keypad
acts only as a display.
The Keypad will display
• printer messages
• error messages (for the Interface)
• queue status
• film supply quantity
• the image store positions
The image store positions (map) will show the current page layout or where the
images have been stored within this layout. The map will indicate stored images in
red and layout in green.
• the LED window below the COPIES
This LED will indicate the number of multiple originals to be printed.
• the LED window below the FORMAT
This LED indicates the present format number.
Note
When changes are made at the imaging device, the Keypad is updated when the imaging
device sends the information to the Printer.
4–28
QUEUE:00
5B9615