Reaching The Main Menu - Kodak Ektascan 2180 User Manual

Reaching the Main Menu

Follow these steps to reach the Main Menu:
[1] Verify that the Control Terminal is turned on. The ON/OFF switch is on the right
side of the Terminal, with the Brightness and Contrast adjustments.
[2] If the Display Screen is blank, press any key to display the Main Menu. If the Main
Menu does not appear, see the Troubleshooting section for the Control Terminal.
Important
Select menu item 1 below only if the terminal type is WYSE. If the Terminal is not a
WYSE terminal and item 1 is accidentally selected, the Mode Selection Menu will be
displayed. At that menu, press [Esc] to return to the Terminal Type Menu and select
item 2.
If the user indicates a WYSE terminal specification when it is not a WYSE terminal, and
makes a selection from the Mode Selection Menu, with the non-WYSE terminal, the
Control Terminal display may show a garbled message.
If the user presses [Esc] and the system returns to the Mode Selection Menu, nothing
further needs to be done. If the Terminal does not respond to the [Esc] key, the terminal
parameters may have been changed by the error. Reset the parameters to their original
values, and press [Esc]. At the Terminal Selection Menu, select the correct specification.
5B9615
Control Terminal
5–5