Start-Up And Shutdown - Kodak Ektascan 2180 User Manual

User's Manual

Start-Up and Shutdown

Start-Up
[1] If a Processor is attached to the Laser Printer, see the procedure in Section 14 of
Part II of this User's Manual to start-up the 180 LP or 180 LPS Processor.
[2] Turn on the main power switch for the Printer.
Processor main
power switch
Note
If the [Print] command is used to print an image before the solutions in the Processor
have reached the correct temperature, the Printer displays a message that the Processor
is not ready. The films will remain in the Image Buffer until the Processor becomes
ready.
(You may override the message and send the film to the Processor by using the override
function on the Printer Control Processor Screen. See "Control Processor Screen" in
Section 11 of Part II of this User's Manual for more information.)
There are no films waiting in the print queue if the Printer Display Screen shows the
Printer state as "Ready."
3–2
Printer
main
power
switch
display
screen
film
door
H126_0703ACE
H126_0703AA
5B9615