Kodak Ektascan 2180 User Manual page 212

User's Manual
Removal of the Developer Filter
Figure 15–1
developer
filter
[15] Change the Developer Filter each month. Follow these steps to change the
Developer Filter.
(a) Check that all electrical power to the Processor is OFF.
(b) Lift the Top Cover of the Processor.
(c) Remove the Wet Section Cover, and the Replenisher Hose from the Mandrel
Assembly as illustrated.
Note
When removing the Mandrel Assembly, place a Drip Tray under it to prevent
contamination of the fixer.
(d) Rotate the Mandrel Assembly so that the notch in the top of the Mandrel
Assembly is aligned with the clip on the Level Sensor Housing.
15–10
mandrel
replenisher
hose
H127_0135GCA
H127_0135GA
5B9615