Kodak Ektascan 2180 User Manual page 68

User's Manual
Select Destination Screen
To select the destination for your exposed films, press the [F2] Control Panel function
key while at the Other Functions Screen. The current destination is shown as selected on
the screen.
A Printer can be calibrated to support up to five remote Processor sites. If the Receive
Magazine is selected, you must select a Processor site so that the correct system
calibration can be used.
You will use the Select Destination Screen when you set up your Printer and when
changing from the docked Processor to the Receive Magazine to print or changing back
to the Processor. This feature tells the Printer whether your exposed films should go to
a docked Processor or a Receive Magazine. If you add a Processor to your Printer at a
later date, you will use this screen to change the destination of films.
3–42
SELECT DESTINATION
Docked Processor
Receive Magazine
Site 1 Site
Site 2 Site
Site 3
F1 Select Docked Processor
F2 Previous Site
F3 Next Site
F6 Return
Make the desired selection(s).
Ready
4
5
H126_9030AC
5B9615