Table of Contents
Advertisement
Automatic Replenishment Mode
This is the standard replenishment mode of the Processor. In this mode, replenishment
will occur under 2 conditions:
• The replenishment cycle is activated each time approximately 1500 cm
of film has been processed. This is equivalent to one 35 x 43 cm (14 x 17 in.) sheet
of film. The amount of replenisher that is added for each 1500 cm
processed film can be adjusted by the operator within a certain range. The default
amounts are 60 mL of developer and 85 mL of fixer.
• The Processor will replenish to compensate for low film usage. Low-volume
applications are those processors that process less than 75 sheets of film in 24 hours
(for continuous-run applications) or over 2 power-up cycles (where the last cycle is
more than 3.5 hours on the replenishment timer). A low-volume application is
further divided, and different replenishment volumes are added accordingly for
proper control:
Sheets on Current Film Count
less than 55 sheets
56 - 65 sheets
66 - 74 sheets
Note
The Replenishment Pumps will automatically turn on every
period when extra replenisher is added. This is the normal operating procedure. Do not
be alarmed.
5B9615
Setting Up the Processor
Replenishment Added over 4 Hours
⁄
1
1 L (125 mL/
hour)
2
⁄
1
750 mL (93 mL/
hour)
2
⁄
1
400 mL (50 mL/
hour)
2
⁄
1
hour during the 4-hour
2
2
2
(238 in.
)
2
2
(238 in.
) of
13–7
Advertisement
Chapters
Table of Contents
Troubleshooting
