Tip Identification; Vantage And Titan System Tip Identification; Fortus System Tip Identification - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide

Tip Identification

Vantage and Titan System Tip Identification

When building with WaterWorks material on an FDM Titan or an FDM
Vantage, use the T12 WW support tip for model tips: T10, T12, and T16.
Note: The T12 WW tip has a finned flange and two line
markings on the tube.
Figure C-1: Vantage and Titan WW Tip Identification
If a T20 tip is used for the model material, use a T20 tip for the support
material (they are the same tip part number for both model and support).

Fortus System Tip Identification

When building with WaterWorks material using a Fortus eV, Fortus eT,
Fortus 360mc/400mc or Fortus 900mc system, the T12 SR support tip must be
used for all indicated model tips. The T12SR20, T12SR30, and T12SR-100 tips
are clearly marked on the top-side of the plate and are slightly shorter than the
model tips.
Figure C-2: Fortus eV, eT, 360mc/400mc, and 900mc Tip Identification
All model and support tips
are interchangeable -
EXCEPT for the Soluble
Release support tip.
Tip Size is imprinted on top-
side of plate
(T10, T12, T16, T20).
The T12 WW
support tip has a
finned flange.
The Soluble Release support
tip is shorter than the
standard tips.
Soluble Release support tip
is imprinted with T12SR on
top-side of plate (T12SR20,
T12SR30 and T12SR-100).
C-5