Clean Exterior Surface Of System; Clean The Liquefier Tips; Replace An Interior Lamp - Stratasys FORTUS 360mc Manual

Clean Exterior Surface of System

Exterior surfaces of the system may be cleaned using a lightly damp
cotton cloth. Clean the oven door glass with a cleaner that does not
contain ammonia.

Clean the Liquefier Tips

The system automatically cleans the tips before and during each part build
- using the tip cleaning assembly. However, occasionally, material may
build up on the tips that cannot be removed during the auto-cleaning
process. Remove excess material manually using a brass, wooden-handled
brush (included in the Startup Kit).

Replace an Interior Lamp

1.
The interior lamps, located inside the oven, will periodically burn out
and require replacement. Use the following steps to replace a lamp:
A.
Power down the system and allow the oven to cool.
Warning: if the system is not completely powered down, High
voltage Ac is still present in the system. There is a chance that
changing a lamp may expose you to this voltage. All AC line
voltage is eliminated by powering down the system in the
manner described.
Caution: DO NOT continue until the six-minute cooling cycle
has completed. This can be verified by examining the UPS
status LEDs through the back panel grill. DO NOT attempt to
replace the light bulbs if ANY UPS LEDs are still lit!
B.
Turn the main circuit breaker and the UPS power switch off.
C.
Remove the burned out bulb, and install the replacement bulb.
D.
Turn on the Main Circuit breaker, the UPS switch.
E.
Power up the system and verify the lamps are operating.
7-12
FORTUS 360mc/400mc and FDM 360mc/400mc User Guide