Information Available During A Build - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide
5.
Replace Model (or Support) tip with T12..
• Indicates a mis-match between installed tip and tip for which the
part (CMB) file was processed.
• Install the correct tip.
6.
Replace Worn Model (or Support) Tip..
• The system tracks the amount of material extruded through a tip.
You will receive this prompt when tip performance may start to
become compromised. (Tip-life prediction is an estimated value.
Many factors contribute to actual tip-life aside from amount of
material extruded. Actual tip-life may differ from predicted tip-
life.)
• Replace the flagged tip.
7.
Model / Support Mat'l Incompatibility..
• Model and support materials are not of compatible types.
• Load correct material.
8.
Vacuum not present-Please check build sheet
• Vacuum is below minimum for system operation.
• Correct condition - often the result of a poorly positioned build
sheet.
9.
Continue..
• You can choose to ignore the warning and 'Continue' the build,
but part build quality will be unpredictable.
• A warning generated from a mis-match of model/support
compatibility or from low vacuum cannot be bypassed.

Information Available During a Build

The following information is displayed while building a job:
* Job: motor housing (Building)
* Build Time: 0:01 hr of 0:02 hr
* ABS
> Modeler Status..
• 1st line: The name of the build job.
• 2nd line: The elapsed time and total estimated build time -
displayed in hours and minutes.
• 3rd line: The material type and estimated total amount of material
for the build. The build mode is also displayed.
• 4th line: The current height of the job and final Z height of the job.
Note: Press ENTER to go to the System Status screen - (see
"System Status" on
0.1 in3 ABS_SS
page 4-32).
0.1 Mode:Normal
0.010 of 0.950 in
4-9