Loading Material To The Liquefier Tips - Stratasys FORTUS 360mc Manual

F.
The system automatically completes the preloading of the
filament.
• The drive motor advances the filament until it contacts the
filament present switch.
• The drive motor stops, and the LED turns to green flashing.
Caution: Make sure that the thumbwheel door is closed after
filament preload is accomplished.
G.
Close the thumbwheel door.
H.
Load material to the head (see
on page 4-18

Loading Material to the Liquefier Tips

Note: If you are changing to a different material type or
changing tips, follow the procedure outlined in
Tips or Material Type" on
Note: Loading filament to the liquefiers is done in the Idle or
Paused mode only, not while building.
Caution: if the material type is changed, the Tips must be
changed.
1.
Make sure the system is in
2.
From the Main Menu, select
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
3.
Select
Load/Unload Mtl..
Unlock Door <E>
>Load/Unload Mtl..
Change Tips/Mtl..
4.
Select
Load Material..
>Load Material..
Unload Material..
Material Status..
Unplug Tips..
4-18
FORTUS 360mc/400mc and FDM 360mc/400mc User Guide
).
page 4-21.
Pause
Operator Control
|*Tips: Model T16
|*
and press ENTER.
| Calibrate..
| Temp Control..
| Move Head/Stage..
and press ENTER.
"Loading Material to the Liquefier Tips"
or mode.
Idle
and press ENTER.
Support T16
"Changing