Oven Components - Stratasys FORTUS 360mc Manual

>Unlock Door <E>
Load/Unload Matl..
Change Tips/Matl..
3.
If the temperature is high, a warning screen may appear. Press ENTER
again to unlock the door.
Note: Once any door is unlocked and/or opened, system
operation cannot be resumed. Additionally, a manual move
command cannot be sent until all doors are closed. When all
doors are closed, the solenoids reactivate and you can resume
operation.

Oven Components

Gloves: Oven lights are hot! Do not touch without wearing
approved safety gloves.
Oven Lamps
There are two incandescent oven lamps mounted in the two front upper
corners of the oven. The lamps are rated at 240 volts and 40 watts. There is a
lamp (light) switch on the keypad, which you can use to manually turn the
light ON or OFF.
The Platen
The platen is the surface on which parts are built. A plastic build sheet is held
to the 17" x 15" aluminum platen by the vacuum source. The platen has a
waffle pattern machined into the top surface. This allows vacuum to pull
across the entire surface. A silicone rubber o-ring, that runs around the
perimeter of the platen, helps seal the build sheet to the platen.
A debris screen (not a customer removal part) is placed across the vacuum
port, located at the center of the platen, to prevent material particles from
entering the vacuum lines.
3-12
FORTUS 360mc/400mc and FDM 360mc/400mc User Guide
(Figure 3-9)
Figure 3-9: Oven Lamp
| Calibrate..
| Temp Control..
| Move Head/Stage..