Cd Method (Alternate Method); Placing System In Receive Software Upgrade Mode - Stratasys FORTUS 360mc Manual

CD Method (alternate method)

This method is for customers who do not have web access. The Controller
Software Update CD containing the updated .upg file and must be
obtained from Stratasys. Inc.
1.
Insert the Controller Software Update CD into the workstation
computer.
2.
Make sure the system is placed in the receive software upgrade mode.
(See "Placing System in Receive Software Upgrade Mode" on page 7-
2.)
3.
Open the Control Center application and select the Services tab and
then click Update Software. (See Figure 7-1 on page 1.)
4.
Browse to the location of the .upg upgrade file on the Controller
Software Update CD.
5.
Select the .upg file to be downloaded and then press Open. This will
send the file to the Fortus 360mc/400mc.
6.
When the download is complete, select Reboot and Install Software
Upgrade and then press OK at the Fortus 360mc/400mc system.
7.
After the system reboots and the upgrade installation complete, two
options will appear; select Auto Home XYZ.
Placing System in Receive Software
Upgrade Mode
Place the system in software upgrade mode by doing the following:
1.
Place the modeler in the Upgrade mode (Maintenance >
Administration > Receive Software Upgrade or Code).
• The operator panel will display the following message.
>Waiting for Software Upgrade or Code
Press MENU key to Cancel
2.
The system is now in the receive software upgrade mode.
7-2
FORTUS 360mc/400mc and FDM 360mc/400mc User Guide