Xy And Z Tip Offset - Manual Start - Stratasys FORTUS 360mc Manual

XY and Z Tip Offset - Manual Start

Note: If the support layer is not centered on the model layer,
an XY and Z Offset should be performed.
Note: Perform an
Offset) - Manual Start" on page 6-9
1.
Build the Calibration Model
A.
From the Main Menu select Operator Control and press Enter.
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
B.
Select Calibrate and press Enter.
Unlock Door <E>
Load/Unload Mtl..
Change Tips/Mtl..
>Calibrate..
C.
Select Calibration Job and press Enter.
Set Z Stage Zero..
AutoCal Tips <E>
Tip Offset Value..
AutoHome XYZ <E>
2.
At completion of the calibration model, 'read' the model and calibrate
the system by following paragraphs 2. through 5. from
Offset Calibration" on
6-10
FORTUS 360mc/400mc and FDM 360mc/400mc User Guide
"Auto Tip-Tip Calibration (AutoCal Tip
|*Tips: Model T16
|*
| Temp Control..
| Move Head/Stage..
|>Calibration Job <E>
page 6-2.
before XY and Z Offset.
Support T16
"XY and Z Tip