Reheating With Laboratory Ovens; Reheating With A Hot Air Gun; Material Safety Data Sheets (Msds; Material Abbreviations - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide

Reheating with Laboratory Ovens

A laboratory oven is beneficial because its designed for tabletop use. The
advantage of using a laboratory oven is that the oven cycle control tolerance
band is small.

Reheating with a Hot Air Gun

If you choose to use a hot air gun, Stratasys recommends using an
electronically controlled hot air gun with an adjustable temperature and air
flow.

Material Safety Data Sheets (MSDS)

You can receive a copy of the MSDS sheets for PPSF and PPSF_S filament and
the PPSF build sheet by accessing our customer log-in site at
www.stratasys.com.

Material Abbreviations

Finishing

Sealing/Adhesive

Follow these general procedures to maximize bonding strength:
• Remove all surface contaminants.
• Apply the solvent to both surfaces and quickly assemble the two
parts to prevent excessive solvent evaporation.
• Clamp the parts together while maintaining uniform clamping
pressure for as long as the adhesive or application dictates.
Caution: Read and follow the adhesive/sealer directions.
Always provide adequate ventilation and follow safety
procedures suggested by the adhesive/sealer manufacturer,
EPA, NIOSH, and OSHA when using adhesive/sealer for
bonding or sealing.
Stratasys recommends sealing PPSF with the product, Weldon 3. The other
products listed in the following table produced varied results.
Material
PPSF model material
PPSF support material
Abbreviation
PPSF
PPSF_S
A-11