Canister Bay; Accessing The Bays; Canister Bay Components - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide

Canister Bay

Accessing the Bays

The canister bays are accessed by opening the canister bay door on the front of
the system (Figure
interlock system and, therefore, can be opened during system operation.
(Shown with 4 operable bays - Large Oven Option)
Model Material
Canister

Canister Bay Components

1.
The Canister Bay
A.
The standard 360mc/400mc system has two operating material
bays - 1 model and 1 support.
• An optional four bay upgrade (large oven option) is available
for the system and can be added before or after system
installation.
B.
For 2 bay systems, the middle two bays are operating bays.
• The middle left bay holds modeling material; the middle right
bay holds support material.
• The two end bays can be used for canister storage.
3-13). The canister bay door is not a part of the door safety
Figure 3-13: Canister Bay Components
Canister
LEDs
Canister Drive
Levers
Support Material
Canister
Vacuum
Gauge
Air Pressure
Gauge
Purge Waste
Bucket
3-15