Platen Flatness Diagnostic; Clean Exterior Surface Of System; Clean The Liquefier Tips; Replace An Interior Lamp - Stratasys Fortus 360mc User Manual

Platen Flatness Diagnostic

1.
If a part fails to adhere to the build sheet or the tip digs into the build sheet,
the platen may not be flat. Five measurements are taken for the diagnostic,
one in each corner of the platen and one in the center of the platen.
2.
To check the platen flatness:
A.
B.
C.
D.

Clean Exterior Surface of System

Exterior surfaces of the system may be cleaned using a lightly damp cotton cloth.
Clean the oven door glass with a cleaner that does not contain ammonia.

Clean the Liquefier Tips

The system automatically cleans the tips before and during each part build -
using the tip cleaning assembly. However, occasionally, material may build up
on the tips that cannot be removed during the auto-cleaning process. Remove
excess material manually using a brass, wooden-handled brush (included in the
Startup Kit).

Replace an Interior Lamp

1.
The interior lamps, located inside the oven, will periodically burn out and
require replacement. Use the following steps to replace a lamp:
A.
Warning: If the system is not completely powered down, High
voltage AC is still present in the system. There is a chance that
changing a lamp may expose you to this voltage. All AC line
voltage is eliminated by powering down the system in the
manner described.
Install a new build sheet.
Verify that the vacuum gauge reads -15 Hg or higher (more negative).
Select
Maintenance>Measure Flatness
displayed. The diagnostic is also stored in the job log in case it is necessary
for Customer Support to view the diagnostic.
* Z Height Measurements
UL: -0.0050
Center:
LL: 0.0120
Verify that all numbers are within ± 0.015".
Power down the system and allow the oven to cool.
. The following screen is
UR: 0.0020
0.0000
LR: 0.0090
7-11
*