Factory Setting - Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual

16.1

Factory setting

Reset to
factory setting
Confirm
(settings will be lost)
Cancel
Fig. 98: Confirm reset to factory setting
Installation and operating instructions Wilo-Yonos GIGA2.0-I/-D
Reset
NOTICE
Resetting pump settings to factory settings replaces the current pump settings!
The table gives an overview of the factory settings:
Settings
Set control mode
Settings assistant
Pump On/Off
Twin-head pump operation
Connecting twin-head pump Single pump: not connected
Twin-head pump alteration
External interfaces
SSM/SBM relay
Relay function
SSM relay function
Trigger delay
Reset delay
DI1
AI1
AI2
Wilo Net
Wilo Net termination
Wilo Net address
Display setting
Language
Units
Pump kick
Pump kick time interval
Diagnostics and measured
values
Diagnostics help
SSM forced control (normal,
active, inactive)
SBM forced control (normal,
active, inactive)
Additional settings
Pump kick
Yonos GIGA2.0
Δp-v
Motor on
Twin-head pump: connected
24 h
SSM
Only errors
5s
5s
active (with cable bridge)
configured
Type of use: differential
pressure sensor
Sensor position: pump flange
Signal type: 2 ... 10 V
not configured
switched on
Twin-head pump
Main pump: 1
Pump partner: 2
Single pump: 126
English
3
m, m /h
switched on
24 h
inactive
inactive
switched on
en
Yonos GIGA2.0 ... R1
Basic control mode
n-const.
Motor on
Single pump: not con-
nected
Twin-head pump: con-
nected
24 h
SSM
Only errors
5s
5s
active (with cable
bridge)
not configured
not configured
switched on
Twin-head pump
Main pump: 1
Pump partner: 2
Single pump: 126
English
3
m, m /h
switched on
24 h
inactive
inactive
switched on
191