Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual page 150

en
Δp-v
Setpoint
Q is = 70.8 m³/h
Fig. 34: Home screen setpoint adjustment Δp-
v
150
Commissioning
Fig. 33: Home screen
Item Name
1 Main menu over-
view
1.1 Status area:
Error, warning or
process informa-
tion display
2 Title bar
3 Setpoint display
field
4 Setpoint editor
5 Active influences
6 Operating data and
measurement area
Table 17: Home screen
Setpoints can be changed in the "Home screen" menu.
Pressing the operating button activates the setpoint adjustment. The frame of the
changeable setpoint turns yellow.
The setpoint is changed by turning the operating button right or left.
Pressing the operating button again confirms the changed setpoint. The pump accepts
the value and the display returns to the main menu.
Pressing the back button
the setpoint. The pump shows the main menu with unchanged setpoint.
Active influences of the pump status on the display in the home screen for single
pumps
The active influences are listed from highest to lowest priority:
Explanation
Selection of different main menus
Indicates an on-going process, warning or error message.
Blue: Process or communication status display (CIF mod-
ule communication)
Yellow: Warning
Red: Fault
Grey: There are no processes running in the background,
there are no warning or error messages.
Display of the currently set control mode.
Displays currently configured setpoints.
Yellow frame: You have pressed the operating button to
open the setpoint editor and change the value.
Display of influences on set control mode,
E.g. EXT. OFF. Up to four active influences can be dis-
played.
If a twin-head pump connection is set up, the status of
the twin-head pump is displayed here.
Shows current operating data and measured values. The
displayed operating data depend on the set control
mode. They are displayed alternately.
without confirming the changed setpoint will not change
WILO SE 2022-05