Setting The Setpoint Source - Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual

Control settings
Parameter Kp
Parameter Ti
Parameter Td
Fig. 43: Setting PID parameters
10.3

Setting the setpoint source

Setpoint source
Internal setpoint
Analogue input (AI2)
CIF module
Fig. 44: Setting the setpoint source
Installation and operating instructions Wilo-Yonos GIGA2.0-I/-D
Control settings
PID specific parameters
If the control mode "PID control" is selected, the submenus "Setpoint PID", Parameter
Kp, Parameter Ti, Parameter Td and control inversion open in the "Control setting"
menu. The desired percentage value can be set as the setpoint in the "PID setpoint"
menu.
In the Kp, Ti and Td parameter submenus, the parameters can be set as the setpoint ac-
cording to the desired behaviour.
The control inversion can be switched off and on.
After setting the desired values, the "Control setting" menu opens again.
Universal Display text
1.0 Settings
1.1 Control settings
1.1.1 Control mode
1.1.2 PID Setpoint PID
Setpoint = Setpoint =
2
1.1.3 Kp Parameter Kp
2
1.1.4 Ti Parameter Ti
2
1.1.5 Td Parameter Td
2
1.1.6 Control inversion
OFF Inversion OFF
ON Inversion ON
2
The menu item only opens if control mode PID is set.
NOTICE
The setpoint can only be adjusted if the setpoint source is set to "Internal setpoint".
If "Internal setpoint" has not been selected in the "Setpoint source" menu, the green
adjustment bar in the "Setpoint" menu is not active. No setting can be changed.
To set the setpoint source, select the following in succession:
Universal Display text
1.0 Settings
1.1 Control settings
1.1.9 Setpoint source
The following setpoint sources are available to select from:
Universal Display text
1.1.9 / 1 Internal setpoint
1.1.9 / 2 Analogue input (AI2)
1.1.9 / 3 CIF module
The setpoint source "Internal setpoint" can be set in the display. The setpoint sources
"Analogue input AI2" and "CIF module" expect a setpoint from an external source.
NOTICE
A CIF module can only be selected as a setpoint source if a CIF module is installed.
The menu item cannot otherwise be selected.
If the setpoint is set via the analogue input AI2, the analogue input can be con-
figured in the "Settings" menu.
2
2
2
2
en
157