Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual page 161

Settings
Control settings
External interfaces
Dual pump management
Fig. 50: Dual pump management menu
Installation and operating instructions Wilo-Yonos GIGA2.0-I/-D
Double pump operation
Universal Display text
1.0 Settings
1.4 Dual pump management
1.4.1 Connecting twin-head pump
1.4.1.1 Twin-head pump partner address
1.4.1.2 Establish twin-head pump connection
Confirm (Pump will re- Confirm
set!) (pump will reset!)
Double pump pairing Twin-head pump pairing status
status
Pairing in progress... Pairing in progress...
Pairing successful. Pairing successful
Pairing failed. Pairing failed
Reset will follow. Reset will follow
Partner not found. Partner not found
Partner already paired. Partner already paired
Partner incompatible. Partner incompatible
Partner Node-ID: Partner node ID:
Cancel Cancel
1.4.2 Disconnecting twin-head pump
Confirm (Pump might Confirm
reset!) (Pump might reset!)
1.4.3 Twin-head pump function
1.4.3.1 Main/reserve
1.4.3.2 Peak-load operation
1.4.4 Pump cycling
1.4.4.1 Time-based pump cycling: ON/OFF
1.4.4.2 Time-based pump cycling: Interval
1.4.4.3 Manual pump cycling
Confirm Confirm
Cancel Cancel
1.4.5 Pump housing type
1.4.5 / 1 Single pump
1.4.5 / 2 Twin-head pump (left):
1.4.5 / 3 Twin-head pump (right):
The following settings are possible with no existing twin-head pump connection:
ƒ
Twin-head pump connection.
ƒ
Pump housing type
The following settings are possible with an existing twin-head pump connection:
ƒ
Disconnect twin-head pump.
ƒ
Twin-head pump function
ƒ
Set pump cycling.
ƒ
Pump housing type
NOTICE
With a factory-supplied twin-head pump, the twin-head pump connection is pre-
configured and active.
en
161