Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual page 136

en
Fig. 19: Threaded cable glands/cable bushings
136
Electrical connection
NOTICE
Factory-mounted:
threaded cable gland M25 for the mains connection and threaded cable gland M20
for the cable for the differential pressure sensor/twin-head pump communication.
All other threaded cable glands M20 required must be provided by the customer.
CAUTION
In order to ensure IP55, unoccupied threaded cable glands must remain closed with
the plugs provided by the manufacturer.
• When installing the threaded cable gland, make sure that a gasket is installed be-
low the threaded cable gland.
1. Screw in threaded cable glands as required. Observe the tightening torque. See
"Electronic module tightening torques" [} 144] table in the "Turning the display"
[} 143] section.
2. Make sure that a gasket is fitted between the threaded cable gland and the cable
bushing.
The combination of threaded cable gland and cable bushing must be made according to
the following "Cable connections" table:
Connection
Electrical mains connection
3~380 V AC ... 3~440 V AC
1~220 V AC ... 1~240 V AC
SSM/SBM relay
1~220 V AC ... 1~240 V AC
12 V DC
Digital input 1 (only EXT.
OFF)
(24 V DC)
Bus Wilo Net
(bus communication)
Analogue input 1
0 ... 10 V, 2 ... 10 V,
0 ... 20 mA, 4 ... 20 mA
(differential pressure sensor
only)
Analogue input 2
0 ... 10 V, 2 ... 10 V,
0 ... 20 mA, 4 ... 20 mA
(External setpoint sensor)
CIF module
(bus communication)
Electrical connection of the
fan (depending on type)
assembled at the factory
(24 V DC)
Table 9: Cable connections
Threaded cable gland
Plastic
Plastic
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
Cable Terminal
bushing no.
Fig. 19,
Item
1 1 (Fig. 20)
2.3 2.3
(Fig. 20)
4, 5, 6 11 ... 12
(Fig. 20,
Fig. 21),
DI1
4, 5, 6 15 ... 17
( Fig.20,
Fig. 21)
4, 5, 6 1, 2, 3
(Fig. 20,
Fig. 21)
4, 5, 6 4, 5
(Fig. 20,
Fig. 21)
4, 5, 6
7 4 (Fig. 20)
WILO SE 2022-05