Maintenance Section; Torque Specifications - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

A A
B B
6 7 6 7
7 6 7
6
037-05-05-113A
Figure 62: Weld-deck shipping—distribute and secure the load
Evenly distribute the load by alternating the direction of consecutive weld-decks. One faces forward, the next faces rearward
(A, B) and repeat.
4. Secure the weld-deck(s) to the transport deck with appropriately sized chains (6, 7), etc. Note: Refer to the Equipment
Information Section of the Weld-Deck's Operation and Maintenance Manual for Weld-deck weights and dimensions.

Maintenance Section

Torque Specifications

Notice
Be very careful never to mix metric with U.S. customary (standard) fasteners.
Mismatched or incorrect fasteners causes machine damage or malfunction and can result in personal injury.
When replacing nuts, bolts, or hardware in general, always use the same measurement and strength type as the original.
Note: The information listed below is for general layout fasteners only. Consult the specific modules' operation and
maintenance manuals —Compressor, Engine, Generator, etc.—in the appendices at the end of the Weld-Deck Operation and
Maintenance Manual, Weld-Deck welding package CPW 125-4-S2-4for detailed information on the fasteners used in the
respective module.
Note: The center mounting bolt and nut on the vibration isolators have specific torque values which are different than the
torques for standard fastener. Refer to the Torques for Vibration Isolator Mounts table in this section of this manual.
72
037-08OP-002D-01 S/N CB50600021 – UP (Weld-deck)