Do Not Operate (1); Electrical Shock (2) - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Do Not Operate (1)

WARNING! Do not operate or work on this machine unless you have read and understand the instructions and
warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could
result in injury or death. Contact your dealer for replacement manuals. Proper care is your responsibility.
Safety message (1) is located on main door of the control/distribution center.
037-05-63-307A
Figure 1: Do not operate (1)

Electrical Shock (2)

WARNING! Shock/Electrocution Hazard! Read and understand the instructions and warnings in the Operation and
Maintenance Manual. Failure to follow the instructions or heed the warnings could cause serious injury or death.
High voltage poses an electrocution hazard; this equipment must be operated by qualified personnel only.
DO NOT OPEN the inner main panel door unless you are a qualified service technician, and are familiar with the
dangers of high voltage. DO NOT REMOVE the rear access cover unless you are a qualified service technician, and
are familiar with the dangers of high voltage. The main electrical lines coming into the bottom of the main supply AC
circuit breaker (CB1) from the genset are LIVE, and HIGH VOLTAGE is present on the main incoming lines
WHENEVER the genset is running, EVEN WHEN THE MAIN CIRCUIT BREAKER (CB1) IS DE-ENERGIZED
(O).
6
037-08OP-002D-01 S/N CB50600021 – UP (Weld-deck)