Table of Contents
Advertisement
ETHYL ETHER CYLINDER
Warning! Explosion hazard! When maintaining or troubleshooting these systems, always make sure that you
are in a well ventilated area away from heat, open flames, or sparks. Wear goggles when testing to avoid eye
injury. Make sure that openings of the valve, tube, or atomizer are pointed away from yourself while testing.
The ethyl ether used in this starting fuel for these systems is extremely flammable, toxic, harmful, or fatal if
swallowed, do not induce vomiting. Call physician immediately.
If fuel enters eyes or fumes irritate eyes, they should be washed with large quantities of clean water for 15
minutes. A physician, preferably an eye specialist, should be contacted.
Do not store cylinders in temperatures above 71°C (160°F). Contents are under pressure. Do not incinerate,
puncture, or attempt to remove center core valve or side safety valve from cylinder.
Figure 14: Ethyl Ether Cylinder; typical note located on ether cylinder on Genset Engine
037-08OP-002D-01
037-09-011
S/N CB50600021 – UP (Weld-deck)
037-09-50-304A
19
Advertisement
Chapters
Table of Contents
Troubleshooting
