Turn the battery disconnect switch key to the off (O) position and remove the battery disconnect switch key when you
service the electrical system or you service any other components on the equipment. See also the General Hazard
Information section in this manual.
Turn the battery disconnect switch key to the off (O) position and remove the battery disconnect switch key when the
equipment is left for an extended period of one month or longer. This procedure will prevent a short circuit from draining
the battery. This procedure will also prevent the components from draining the battery. This procedure will also prevent the
battery from being drained by vandalism.
Operator Controls
Emergency Stop
Figure 23: Emergency Stop Button
Genset Emergency Stop —Located on the Control/Distribution Center, the button is RED in colour with a YELLOW
surrounding collar.
Push the RED emergency stop button to IMMEDIATELY trip the main breaker to cut the genset electrical power, and to
IMMEDIATELY remove all 24VDC electrical power from the Control/Distribution Center, and to stop the genset, if any
type of emergency condition exists. The RED emergency stop button must be pulled out to reset.
Note: The emergency stop button cuts all 24 VDC voltage from the Control/Distribution Center, including engine crank
control. Ensure that the emergency stop button is fully pulled out prior to starting the genset.
037-08OP-002D-01
037-05-63-308A
S/N CB50600021 – UP (Weld-deck)
037-05-63-308B
41