1.1 Warnings - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

---------------------------------------------------------------------------------------------------------------------------------------------------
the vehicle complies with all applicable federal regulations. Any modifications performed on the vehicle prior to the final
state are also considered intermediate stage manufacturing and must be certified as to compliance. The installer of this
crane and body is considered one of the manufacturers of the vehicle. As such a manufacturer, the installer is responsible
for compliance with all applicable federal and state regulations, and is required to certify that the vehicle is in compliance.
Requirements as specified by 29 CFR part 1910.180 (C) (1). In applications, where the rotation of the load is hazardous, a
tag or restraint line should be used, (ref. OSHA 1910.180(h)(3)(xvi)). To reduce the potential for the load to rotate or rope
twist, operate at minimal boom angles and extension.
warranty or liability. Also failure of the crane may result.
and/or personnel!
applications involving the lifting or moving of personnel. Any such use is considered to be improper and the seller shall not
be responsible for any claims arising from such use. This sale is made with the express understanding there is no
warranty the goods are fit for the purpose of lifting or moving persons or other improper use. There is no implied warranty
or responsibility for such uses.

1.1 WARNINGS

Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related.
Federal law (49 cfr part 571) requires that the Final Stage Manufacturer of a vehicle certify that
It is the further responsibility of the installer to comply with the OSHA Truck Crane Stability
Do not attempt to lift or drag a load from the side! The boom can fail far below its rated capacity.
Do not weld, modify, or use unauthorized components on any Auto Crane unit! This will void any
Failure to correctly plumb and wire crane can cause inadvertent operation and damage to crane
Auto Crane Company remote controlled cranes are not designed or intended for use for any
6