Fire Prevention And Explosion Prevention; General; Wiring - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Fire Prevention and Explosion Prevention

General

All fuels, most lubricants, and some coolant mixtures are flammable.
To minimize the risk of fire or explosion, the following actions are recommended.
Always perform a Walk-Around Inspection, which may help you identify a fire hazard. Do not operate a machine when a
fire hazard exists. Contact your dealer for service.
Do not operate a machine with a fluid leak. Repair leaks and clean up fluids before resuming machine operation. Fluids that
are leaking or spilled onto hot surfaces or onto electrical components can cause a fire. A fire may cause personal injury or
death.
Remove flammable material such as leaves, twigs, papers, trash, and so on. These items may accumulate around hot areas
and hot parts on the machine.
Clean all flammable materials such as fuel, oil, debris, etc. from the machine.
Do not operate the machine close to the any flames.
Do not weld or flame cut on tanks or lines that contain flammable fluids or flammable material. Empty and purge the lines
and tanks. Then clean the lines and tanks with a nonflammable solvent prior to welding or flame cutting. Ensure that the
components are properly grounded in order to avoid unwanted arcs.
Dust that is generated from repairing nonmetallic components may be flammable and/or explosive. Repair such components
in a ventilated area away from open flames or sparks. Use suitable Personal Protection Equipment (PPE).
Inspect all lines and hoses for wear or deterioration. Replace damaged lines and hoses. The lines and the hoses should have
adequate support and secure clamps. Tighten all connections to the recommended torque. Damage to the protective cover or
insulation may provide fuel for fires.
Store fuels and lubricants in properly marked containers away from unauthorized personnel. Store oily rags and flammable
materials in protective containers. Do not smoke in areas that are used for storing flammable materials.
Properly clean areas of spillage.
Never store flammable fluids in the operator compartment of the carrier vehicle.

Wiring

Check electrical wires daily. If any of the following conditions exist, replace parts before you operate the machine.
•
Fraying
•
Signs of abrasion or wear
•
Cracking
•
Discoloration
•
Cuts on insulation
•
Other damage
037-08OP-004B
037202650021 – UP (Auto Tie-in Crane)
14